Rays will not trace through a glass-air interface in Non Seq Mode


Rays will not trace through a glass-air interface in Non Seq Mode

Author
Message
frogomentich
frogomentich
Forum Newbie
Forum Newbie (20 reputation)Forum Newbie (20 reputation)Forum Newbie (20 reputation)Forum Newbie (20 reputation)Forum Newbie (20 reputation)Forum Newbie (20 reputation)Forum Newbie (20 reputation)Forum Newbie (20 reputation)Forum Newbie (20 reputation)

Group: Forum Members
Posts: 4, Visits: 9
Hello

I have a simple plano-convex lens which will not trace rays attempting to exit the rear surface of the lens when " Use Polarization" is enabled.
The rays will trace just fine if use polarization is disabled. Any clues are greatly appreciated.

The image shows the rays stopping at the rear surface of the cylinder lens.



Mark Moores
Mark Moores
Forum Member
Forum Member (1.1K reputation)Forum Member (1.1K reputation)Forum Member (1.1K reputation)Forum Member (1.1K reputation)Forum Member (1.1K reputation)Forum Member (1.1K reputation)Forum Member (1.1K reputation)Forum Member (1.1K reputation)Forum Member (1.1K reputation)

Group: Forum Members
Posts: 313, Visits: 3K
Did you check the box to allow "ray splitting"?

GO


Similar Topics


Login
Existing Account
Email Address:


Password:


Select a Forum....























































Zemax Users Forum


Search